Skip to content

Tardis Siege Mode

3D model description

I was looking on thingiverse for a tardis model and came across a really neat Siege Mode version. I wanted to print it but no side was flat and the geometry was too dense and messy to clean up.

So I decided to remodel a clean and poly-efficient version myself based off this paper printout version as my template:

3D printing settings

100% scale: Minimum 0.4mm extrusion width/nozzle and 0.2mm layer height. Support only needed for the bottom 4 notches.

Smaller than 100%: Finer details will be lost unless printed at a finer extrusion width/nozzle size.

Larger than 100%: Larger extrusion width than 0.4mm possible, consider adding supports to side details and notches or chop model into individual sides.

  • 3D file format: STL





Add a comment