It is a work done in duo with my sister 😊
The creation of the model and rendering was done by my sister under Maya ( You can follow her on Artstation: https://www.artstation.com/audreypeyrucain 😉)
The conversion of the 3D model, printing and painting was done by myself.
We hope you like the model 🤞
Good luck to all participants #ESUN3D
Printed with a 0.1mm layer
With support, the otter must be raised so that the support covers the pasta and the tail
Be careful when removing the support not to break the pasta, if it breaks, just glue it back on 😅
For the post-treatment I sanded and applied resin to smooth the surface.
For the painting I used citadel paints (Painting under improvement ^^'')
Page translated by automatic translation. See the original version.