Following the Heliox video on Youtube.
I have started production of Protective Visor by 3DVerkstan
I have made some modifications to adapt it following some recommendations. I made several versions available on my 3D Sketchup file.
Especially the side fasteners that end up wearing out the transparent plastic and the visor comes off.
I've adapted the system so that its hooks are properly wedged.
Evolution compared to the basic visor.
Model 1 (the front part is wider for comfort)
Model 2 (I've hollowed out this part for quick printing)
Model 3 (I replaced the nipples by 2 claws that wedge the film)
Model 4 (Model 3 improved for the passage of plastic film)
Model 5 (a mix between the two where there are holes in front and claws on the sides).
I advise you to use the model 4 if you don't have a punch or the latest model.
To help me
My Youtube channel
My site (3D part all my realisations)
Low layer full,
No skirt outline
Nozzle temperature 215 1st layer without fan.
Nozzle temperature 215 other cut with fan.
Tray has 0 because grip surface ok otherwise 60°.
speed 80 mm/s
Page translated by automatic translation. See the original version.