Simple shield board that allows to connect servo-motors and other devices (like sensors) to the analog pins of an Arduino board (UNO or MEGA).
It also has a connector for the batteries.
You can use it in printbots like the MiniSkybot or the ArduSnake!
----- Building tips -----
Â· This circuit can be made easily using pre-drilled PCB board.
Â· You can push the header pins all the way trough to be able to solder them on the other side of the PCB, even with one-layer designs like this one.
----- Notes -----
Â· I have made some tests with an ArduSnake, using a previous version of the same circuit. Here is a video: https://www.youtube.com/watch?v=oEkTYmGqIWo
Â· Still need to make this PCB, but as far I can tell it will work.
Â· Analog pins can be used as digital:
------ A0 -> pin 14
------ A6 -> pin 19
Â· It is my first design using Kicad, please excuse my mistakes.
----- Progress -----
Â· 16/05/12 Built OK, here is a video: http://youtu.be/zC5MKcnZ27Q
Â· 02/05/12 Made a paper version and uploaded pictures
Â· 30/04/12 Uploaded version 1.0 of the board