I had a space problem with the shell of my phone which was not compatible with the radio control of my Mavic from DJI.
So I bought this magnet phone holder mounted on a ball I took a few steps and here is the result !!!
The brand of my support is APPS2CAR...
The central sphere which allows it to rotate is of a diameter of 17mm.
Once the file is printed, you just have to dismantle the ring and reassemble everything on the new sphere on support.
The support that I printed is tried it was subject to wrapping I therefore modified the file so as not to have any more (The nets present on the model were too thick).
The axis which holds the sphere was raised by 8MM so as to have more room to pass the hands (even if that present on the photo is already sufficient)
I will modify this file very soon so that it can accept several types of magnets
I still listen to you to answer your requests
You will find a photo of the measurements.
Infill %: 40-60%
Support : No
Membership : Yes
Practice Makes Perfect
Page translated by automatic translation. See the original version.