Thank you to @FinneganFalco for the original design.
I accidentally ordered the Direct Feed V6 hotend clone instead of a Bowden version. As usual, I thought "challenge accepted!"
Using the same ideas as my extruder plate design, this adapter allows you to mount @FinneganFalco's fang and 40mm fan duct to an otherwise direct feed V6 hotend clone or the original E3D hotend.
Using the incorporated pressure fitting and nut, slide your ptfe tube up against the hotend and tighten the nut. You can now use the cheaper Direct Feed hotend without a Bowden fitting.
Enjoy and post your makes!
If you found my Things useful, treat me to a cup of coffee by using the PayPal button below :)
Buy me a cup of coffee
Buy me a cup of coffee $3.00 USD
Buy me a massive cups of coffee $5.00 USD
Give me a caffeine coma $10.00 USD