Support for E3D v6 clone hotend in Bowden.
In this model:
Take advantage of the Ender 3 hotend support (no need to remove the trolley).
It takes advantage of the Ender 3 thermistor and its 2 fans (it is not necessary to touch circuitry).
4 screws M3x10 (not exagonal)
2 screws M3x20 (not exagonal)
8 x 2x10 (or 2x12) joinery screws
IMPORTANT: It is an unfinished project and the coating fan duct is not yet available. If there is any suggestion as to how it should be, proposals are accepted.
With a recommended filler of 15-20%.
Can be printed on PLA
The duct for the heatsink fan is recommended ABS (as it touches the hotend heater wires) Although with PLA the deformation is almost negligible (working at 200-220C)
Page translated by automatic translation. See the original version.