This is a simple little clip for managing wire and cable on aluminum extrusion, specifically 15 Series (1515) extrusion. The loop is intentionally offset from the extrusion so to work with components likes Fath's Uniblock ( https://bit.ly/2GaztKg ) or other T-Slot hardware.
There is a small slot for use with 4in Cable Ties ( https://bit.ly/2pDELaL ). The cable tie is not necessary, but is nice for getting wires taut or preventing them from coming out.
Because of the flexibility and strength required, it is recommended ABS be used to print the part.
Three Sizes: 5mm, 7mm, 9mm