Another dishwasher magnet because why not... I had some old hard drive and cd drive magnets and an idea.
About half way through printing the orange one I dropped in a few CD/DVD drive magnets (the small square ones)
When the white one was done printing I cut one small slit in the corner at each end and slid in the magnets from the hard drive (thin curved magnets)
The orientation should be correct for printing (see pic) Standing up and at a angle.
Printing at a diagonal from the x and y axis allows the print head to move out of the way enough to slide the square magnets into the rounded ends. Wait till it is about half way through or the auto leveler might suck the magnet back out if it gets too close. The hot end is hot, don't burn yourself.
Turning ideas into products with 3d printing