Skip to content

Beach umbrella holder for your bike

3D model description

Have you ever wanted to go out for a ride with your bike, but it’s so hot and sunny you‘re going to melt like an ice cream in august?
We have the solution for you!

With these easy printable pieces, you can use a standard beach umbrella and ride in a continuous shade that is always above you. And if you have a waterproof beach umbrella, you can also ride when it rains. And there is more!, you can use to transport your beach umbrella
It is adjustable to different angles in order to fit different bikes. You’ll only need ten M4x12mm screws and nuts. Adjust angle and mount center screw first because later it won’t fit. There are two different supports, with and without hole (upper and lower supports respectively).

I used 0,2mm layer, 30% infill (for extra toughness) and no supports.
Enjoy summer with your bike and without sunburns!! And if you like it, share!

3D printing settings

Printer:
ZYYX+ 3D printer

Rafts:
No

Supports:
No

Resolution:
0.2

Infill:
30

  • 3D file format: STL

Creator

License

CC BY SA

Collection associated with this 3D model


Add a comment

One comment

Anne Onymous Anne Onymous

That first picture is deeply flawed. Really hard to stabilize a bike via kickstand when on loose sand like most beaches. I'd hoped the holder would allow the umbrella to feed through into the sand for further stabilization (obviously you'd mount it opposite side of the kickstand instead of same side). But it's closed off adding weight on the bike most frequently causing the kickstand to sink into the sand and the cycle to topple!