Skip to content

Unicorn Night Light

3D model description

A Unicorn Head Nightlight. The head and horn are printed separately. They are designed to be used with small LED lights. There is a bar in the middle of the head that you can use to hook the light on so that it stays in place. There is a similar bar at the bottom of the horn, near the opening. It can be tricky pushing the light past the bar in the horn and I do not recommend printing it at a smaller scale. There is an anchor at the bottom of the head so that you can tie up the wire from the horn to keep the horn tightly in place.

I have printed it with natural PLA and glow in the dark green and blue PLA and they all work fine. Any translucent PLA should be suitable.

For the lights I used one blue and one white LED in the head and one red LED in the horn. They were purchased here:

This is what I used as a power adapter:

I used a three terminal switch, bought here, to switch between the LEDs in the horn and head. A diagram for how to wire a three terminal switch is in the pictures above.

  • 3D file format: OBJ and STL





Add a comment