Skip to content

Nespresso Capsule Honeycomb Snowflake Wall Holder

3D model description

Low-profile modular storage solution for Nespresso capsules.

3D printing settings

Prints well at low res setting (10% infill, 2 shells, 0.3mm layer height)

Note: There is a small lip on the top side of each slot that keeps the capsule in place. The honeycomb should be installed with double-sided foam adhesive so that the lip ends up on the top of every slot.

Each holder holds 7 capsules.

Should print in approximately 48 minutes.

  • 3D file format: STL





Collection associated with this 3D model

Add a comment