Please check out the pictures which explain everything.
The curve board can be used as:
Paper(e,g, coupons, letters. bills...) Organizer
Angle Adjustable Tablet/Phone Stand
Any ideas and recommendations are welcome!
None of the models requires support to print.
Those in the pictures were prints with the following parameters
Plastic: 1.75mm PLA
Layer Height: 0.27mm
Number of shells: 1
Feedrate: 80 mm/s
Travel Feedrate: 56 mm/s
What to print?
Coupon Organizer needs
Tablet Stand needs
Bottle Dryer needs
STL files Explanation:
a single base with radius=100mm, width=120mm
a single base + 3 dividers
a divider with height=45mm, width=120mm.
a stop used to prevent tablet from slipping
three sticks for Bottle Dryer
a short covered connector for slotting two bases.
short uncovered connectors
full length uncovered connectors
a demonstration of how 2 connected bases look like.