Skip to content

Minion Flower Pot

3D model description

Inspired from the Minion Stone Age Planter ( ) i was searching for another Minion Flower Pot and found this nice Minion Figure! I loaded it in Thinkercad and made a Hole in his Head :-D ! That's all.

I made one stl for Indoor and one for Outdoor with three Holes so the Water can be flown out if to much.

3D printing settings

No Support needed. 5% Infill is enough. Made it with 4 Walls, 0.3mm Layer Height. Speed 60mm/s.
Took about 2 hours 40 minutes if scaled to 100mm height

  • 3D file format: STL





Add a comment