I offer you my desk lamp:
Width of the lamp base 15cm
Height of the lamp unfolded to the bottom 52cm
In the backrest you will have the screws, wing nuts and washers.
You will therefore have to print or buy:
two 4x5mm screws
one 2.5x5mm for the lampshade
three M5 washers (not required)
three wing nuts M5
Then buy in addition a socket holder for the bulb with cable, plug and switch.
I took the one where I had to cut the wire to pass it through the lamp and solder the switch closer to the lamp: https://www.amazon.fr/gp/product/B07GJNQFTV/ref=ppx_yo_dt_b_asin_title_o00_s01?ie=UTF8&psc=1
And of course a light bulb.
I printed it in the same color as on the images with Dailyfil's Matte Black PLA:
And beat them with PLA Wood from Sunlu:
I hope you will like it!
If you have any questions, don't hesitate!
Not except for the lampshade and screws.
Page translated by automatic translation. See the original version.