My mixture of the new Supergirl with some of the original movie Supergirl.
If printed with PLA only,you get a semi poseable figure. (hips won't move with solid skirt)
For best results the skirt and cape should be printed with flexible filament (if possible)
Print components, remove supports and sand carefully. (top of hip sockets may need extra sanding for clearance)
Assemble waist and thighs first, place skirt over waist/thigh components, insert shoulder joints into back part of torso then assemble torso pieces over waist pin.
For leg assembly, use 1.75mm ABS filament as pins, hot knife ends smoothly into place.
For arm assembly, use pins provided and hot knife the ends smoothly into place.
Assemble both halves of head.
Cape should be placed on doll before head.
Special note: the cape can be difficult to print (only 1mm thick) you may want to make a simple material cape, instead.
(fixed ripple effect can be achieved by positioning material cape then spraying with clear spraypaint, wait to fully dry, cape should remain in desired position, then attach to doll.)
The skirt and cape do not need to be glued in place.
I added a pair of fists in case any one prefers them. (they will probably print easier than the open palmed ones)
Devoted to EXID.