Old print. Approximately 1/87 scale. On the 1mm version, the axles are 1mm brass rod cut to 30mm. The 2mm version has printable axles, but were unsucessfully printed. Both models need a 8.5mm - 9mm long 1mm rod for the rear door. This is a model I created a while ago, and I will probably revisit it and recreate it in a more detailed fashion.
-Sliding side doors
-Swing-out rear door
This model was created in Designspark Mechanical and printed on a Zortrax M200 at 140 micron in Cool Grey.
A little warning: This was when I was starting to first use DSM to model for 3d printing, so some parts are not perfect, such as the 2 pegs in the back to hold the top on. I had to break them off as there was not as much clearance as there should have been. The top is also not as secure as I would have liked it to be.