Skip to content

"Oana" and "Cristi" named Galaxy Note 2 Case

3D model description

I remixed DrewPetitclerc's Galaxy Note2 case to make one for my phone and my dad's.

I wanted the writing to be subtle enough that it looks like a pattern on initial inspection.

Below are two versions, one which is for use with the regular backing, the other one which can be used if you have a Samsung brand flip cover (it may work with the unbranded ones, I haven't tried), which is slightly thicker, so one side is taller.

3D printing settings

I printed these without any supports or rafting with no problems, so that is possible, though you will have to do a little bit of tidy for some messy edges.

I also found I had to level the build plate further away from the extruder than I usually would. I had some jams before this, but just a fraction lower fixed it.

  • 3D file format: STL





Add a comment