Skip to content

Hair Challenge Pig Hairy

3D model description

Hey Internet People,

I made this challenge because an internet friend proposed it to me, so I thought of something hairy and I thought of imagining a pig with hairs like a porcupine!

This design was made by me in Fusion 360 and Blender is a Thing with Hair to make the hairy challenge, It can be done in an Anet A8 Prusa i3 printer then it can be done with higher 3d printers, it's simple, it takes 7 hours to print depending on your settings, I will be working on a model with more hair, of course it is recommended to print with PLA, you need to have superposition skills in the z-axis must be left with -7.00mm below, that depends on your priorities.

Leave positive comments, like and share it, that would help a lot!


3D printing settings

Material: I made this impression in orange PLA.

Time: The impression takes between half an hour to 7 hours depending on the infill 10% ~ 20%

Infill: 10% ~ 20%

Build Plate Adhesion: You can use Brim if you wish but it's not necessary.

Supports: Don't dare put supports, because it will useless form the hairy effect

Dimensions: 143.8 x 143.7 x 71.9 mm

  • 3D model format: STL



Hey, I'm Alex, I contribute a few part of my time to 3D printing, design stuff-parts, creation of solids and assembly models

Among several activities I like robotics and I work with technology, at the same time I've always an student for this.

Hope you like my stuff!

-I'm not rocket science

Contact me for collaborations!

Follow me on:




Page translated by automatic translation. See the original version.

Related contents

Add a comment