Aller au contenu

Scrubbie V2

Envoyer à un Conseiller

Description du modèle 3D

Well I tried to put my original Scrubbie in the dishwasher which happened to be set on sanitize and some of it melted away. When I went to make myself a new one I realized the bottom layer was unnecessarily thick so I made it a lot thinner and then I had trouble with the bristles so I changed those around too. The one pictured is in Semiflex. Included is a sample scrubbie test piece so you can be sure your settings are correct before printing the whole thing.

We distribute cost effective 50 gram Splash Spools of NinjaFlex and SemiFlex on our own website, Amazon and eBay. Great for trying out flexible filaments or if you need a variety of colors. This scrubbie weighs in at 13 grams.

Paramètres d'impression 3D

J'ai utilisé les paramètres Standard Semiflex dans la version Lulzbot de Cura. Ces paramètres sont recommandés par Flexion_extruder: je mets votre fichier dans Simplify3D avec nos réglages standard (impression de 70 mm / s, retrait de 5 mm à 60 mm / s) et dit 1 heure 16 minutes. Vous pourriez aller plus vite avec moins de rétractation, mais ces paramètres devraient le rendre sympa et propre.

  • Format du fichier 3D : STL

Mots-clefs

Créateur

We developed a great way to distribute cost effective quantities of flexible filament: Splash Spools. A generous amount of filament on a spool with a case so it's not flopping all over the place. Splash Spools store easily in a desk drawer, stacked space or even hang on a wall. Available on www.3dprintNY.com , eBay and Amazon. We stock NinjaFlex, Cheetah, Armadillo, EEL, Filaflex, Flexy2 and Flexy.

Page traduite par traduction automatique. Voir la version originale.

Contenus correspondants


Ajouter un commentaire