Skip to content

Transformers COMBINER WARS Posable Hands

3D model description

Articulated hands for Combiner wars style Gestalts and any other that attach on a 5mm peg. not suitable for holding 5mm peg guns.
note - printed on my ultimaker original plus, this design requires some proper fine tuning like re-drilling the holes for the steel rod, cutting the rod in pieces, there might be some friction issues that will require sanding/filing.

You need to mirror the hand body in your slicer to get the other hand done ;)

the hinges for all fingers are universal, so you will need 5 per hand
middlefinger section is also universal, you need 5 per hand
fingertips - 1 short for thumb, 2 long for middle and 2 regular for sides
1 peg per hand
if you need to have the holes re-drilled i recommend a hand drill of 1mm, anything faster than very slow will cut through like butter (temperature)

3D printing settings

Rafts:
No

Supports:
Doesn't Matter

Resolution:
0,1

Infill:
100

Notes:
i get best results with PLA, on UMO+ with this setup
temp: 215 c
bed: 50 c
layer hight: 0.1
shell: 0.8
bottom/top fill: 0.8
infill: 100%
print speed: 30mm/s (speed applied to ALL categories of printing/travel eg. infill, shell, top, bottom)
support type: everywhere for hand body only, none for fingers and hinges
platform adhension: brim - 20 lines
PRINT ONE AT A TIME - enabled, otherwise you will get horrible stringing

Creator

If you like transformers I invite you to check out the website i write and photograph for

ManiacyFigurek

They are written in polish, but you can always enjoy the photos.

Share

License

CC BY


Add a comment