A small rock cluster to add to the dungeons. My print was done at .15 layer-height. I would recommend trying to print even lower to get the top finish look better. But the best way to go is to sand it or use some filler. (I only sanded a bit before my trash paintjob, you should take a bit more care than that)
I make these models mostly for my own enjoyment. I find it fun to share them with you and I try to hold a professional level of quality to the models. If you use the models and feel that you could spare a dollar or two, a tip would be appreciated. Thank you!
This resolution works, but you should go finer