Skip to content

Simple badge holder V2

3D model description

Just a simple badge holder, nothing more than a smooth edge around your badge. Cards easily slide in from either side and are tightly snapped in place. Model needs supports to print the overhangs that keep the badge in place.

  • Increased thickness for higher durability
  • Slightly lower tolerances for a tighter fit
  • Added overhangs on the sides to prevent cards from accidentally sliding out

Due to the tight and secure fit, frequent removal might damage the card!

3D printing settings

To print the overhangs, I recommend printing high-density supports with increased horizontal expansion. These will easily snap away without damaging the bottom layer. I use the following support settings in Cura:

Placement: Everywhere
Pattern: Triangles
Density: 60%
Z Distance: 0.15mm
X/Y Distance: 0.7mm
Horizontal expansion: 3mm

Resulting supports can be seen in the included picture.

  • 3D model format: STL

Tags

Creator

License

CC BY


Add a comment