Produced with the awesome support from my Patrons!
There are other paint shakers here, but of course I had to do my own. It can contain several different models of citadel paints. I have some that are 20 years old, but still good.
You will also need:
* thick rubber band
* jig saw
* 4 small bolts (holes are a bit over 3mm)
* 4 nuts
* 8 washers
Clamp the paint shaker to the jig saw blade using the bolts. Tighten them quite hard. Put the paint in the cup, secure it with the rubber band. Start the jig saw. Go slowly at first. After a while, when you are confident that the paint pot is secure, go faster. Use protection for your ears.
I added models for this. It's pretty much the same thing but with a little hat to keep the bottle down. Thread the rubber band through the top ring. Make a face against the jig saw. The models isn't symmetrical and the face was the easiest way to fix it.
I make printable 3D terrain for wargaming. Since more than a year I have released all my designs for free. To support this service I would very much appreciate your support on my Patreon page
This is the youtube-channel for my designs. I will present, paint and make proper terrain out of them.
If you like what I am doing and want to encourage me to continue, consider dropping me the occasional tip. If you want to support me and at the same time influence my work, please consider the patreon thing.