This is a minion made on Solidworks.
Problem Statement: With a partner, you will design a “2D” placard using Solidworks. You and your partner will have the same design which meets the constraints below, and you will EACH use Solidworks to create your design.
Should have a flat back; detail will be on the front side
Should fit inside a box that is 10 cm x 10 cm when lying flat
Should be no more than 1 cm thick
Should be as detailed as possible
Detail will be made using sketches that are extruded to different heights
No error messages
Do not extrude contours - each feature should have its own sketch
Part should be CENTERED about the origin
Demonstrate efficient use of construction lines
Demonstrate efficient use of automatic and manual relations
Demonstrate efficient use of Smart Dimensions
Demonstrate efficient use of mirroring
Demonstrate efficient use of linear or circular patterns