Skip to content

Taulman Spool Holder

3D model description

Here's a video explaining the spool holder...

https://www.youtube.com/watch?v=fcPFLtofpFk&feature=youtu.be

This is my solution to fix common problems related to Taulman brand Spools... This design is based roughly on a popular Spool holder design I made a few years ago...

Taulman makes great filament, but their spools are packed to the brim, very tight, with no place the keep the end of the filament controlled... This causes a lot of the spool to completely unwind everywhere... You can either cut it off and waste the filament, or try to wrap it back up and risk getting a snag or your spool locking up later while printing.... My spool holder has a place to keep the end of the filament held... And lockers which lock the spool in place - restricting it from spinning when you don't want it to spin... The dimensions of the spool holder are near perfect, so everything will fit and screw in well - even on low resolution...

Thanks for viewing my spool holder - be sure to like it... I hope you find it useful!!!

#FilamentChallenge

3D printing settings

Print 1 Base Arm, 1 Spinner Arm, and 3 Rods...

Settings can be either .1mm,.2mm, or .3mm or whatever you want for layer height...

Infill doesn't matter... At least 10%...

If you want to make it stronger I suggestion printing with 3 shells or perimeters for strength in the screws... Especially on the base arm...

  • 3D model format: STL

Tags

Creator

License

CC BY SA


Add a comment