This is a two-piece hinged pad for LoboCNC's Quick Clamp, with 10° inclination range on both sides. It allows gripping of non-rectangular objects, and also compensates for slight deformations of the clamp, that causes the jaws not to be perfectly parallel to each other.
There are two versions:
One for a 2 mm peg
One for a 3 mm peg
Supports required just for the bottom part.
Connecting the Two Pieces
Use a drill bit (2 mm or 3 mm, depending on the printed version) to clear the holes of the hinges, where the peg goes. Cut a 2 mm or 3 mm diameter nail to make a 25 mm long peg, and push it carefully through the hinges to connect the two parts.