Skip to content

Anycubic I3 Mega Hotend Cover V3 (7530 radial fan)

3D model description

Now my Anycubic I3 Mega Hotend Cover (V1) was in use for almost a month.
However, it has been shown that the amount of cooling air was not quite sufficient, if overhangs were to be printed on small areas per level.
Then I designed the V2 - but the new fan didn't want to harmonize with the printer electronics.
Therefore now the V3, with which no fan, but a blower is used. This part blows enough air even if it runs at 50%.

Fans used:
- 1x Noctua NF-A4x10 FLX 40mm
- 1x Titan TFD-B7530M12C

BOM:
- 1x screw M4x40 + nut
- 4x M3x30 + nut
- 2x M3x16 + washer + nut
- 2x M3x16 + nut
- 2x M3x10 + nut
- 1x rubber band

  • 3D model format: STL

Tags

Creator

License

CC BY SA


Add a comment