Skip to content

Soap Dishes Remixed

3D model description

I found this soap dish by teachermakesthings. It is a great design, that can be wall mounted. However, I wanted this design to sit on a shelf in my shower, and the current design would trap water in the grooves if it sits on a flat surface, due to the flat bottom. Also the previous design would take 16 hours to print at .2mm and 60mm/s. So I remixed it. I removed the wall mount option and placed drainage holes so this can be set on a shelf in the shower. I reduced it's height which also reduces material cost. I will include another remixed one that can be set on the counter top and will TRAP water instead of allowing soapy water to drain onto the counter top.
Now you can print the shower version in about 3 hours at .2mm layer height and 60mm/s, or both together in about 8 hours.

  • 3D model format: STL





Add a comment