It is a simple flowerpot that will allow him in little time of impression, consuming only 20 meters of filament, to have something practical with drainage to avoid the excessive accumulation of liquids in the interior.
The quality of printing does not make the difference as it seeks to save material and printing time, being the only drawback of low quality, is that it loses liquids, but is within the needs of the pot and the welfare of the plants in its interior.
In addition with the oblique cut of the laminator it is possible to obtain a flowerpot for other showy.
The printed element requires approximately 20 meters of 100% filament.
The printing time in a regular or beginner printer is 3 hours approximately being the general measures of 10 centimeters high by 8 cm in diameter with an angle of 7 units its slope.
Page translated by automatic translation. Suggest a better translation