Skip to content

Dolphin towel holder

Download free STL Dolphin towel holder, LaWouattebeteDownload free STL Dolphin towel holder, LaWouattebeteDownload free STL Dolphin towel holder, LaWouattebeteDownload free STL Dolphin towel holder, LaWouattebeteDownload free STL Dolphin towel holder, LaWouattebete

3D model description

Wall towel holder.

I recycled 13mm metal bars from an old stand that I no longer used, but you can use bars up to 15mm in diameter.

The racks can accommodate 2 bars to put 2 towels, but if the diameter of your bars is too large, too thick towels may not fit (in this case it is better to put only 1 bar). I was afraid that the overhang was too large and that the PLA would not resist, that's why I didn't make a larger gap.

For the assembly, it is necessary to print 2 supports and the 4 dolphins. Dolphins are glued on the supports (neoprene glue is good). I put a color code in the dolphins' names, with an image of the assembly to better understand the principle:

  • the 2 outdoor dolphins (yellow and blue) are not perforated and have 2 pins that center themselves in 2 small holes in the supports

  • the 2 indoor dolphins (green and red) have the same pimples, but have holes to pass the bars

  • The brackets are fixed on a wall with 2 screws.

-You can lock the bars with 2 screws from above the brackets.

It has been several months since I installed it, nothing to report in terms of strength.

3D printing settings

  • PLA Filament

  • 0.2mm resolution

Right dolphins:

  • flat without supports

  • 50min of printing

Dolphins

  • you have to turn them over in order to have the pimples upwards

  • flat without supports

  • 50min of printing

Supports

  • of coast (default proposed position)

  • with supports everywhere

  • about 2 hours of printing

  • 3D model format: ZIP

Tags

Creator

Simple Designer sans prétentions qui souhaite juste partager ses créations.

License

CC BY

Page translated by automatic translation. Suggest a better translation


Add a comment