Skip to content

Mushroom Salt and Pepper Shaker Set

3D model description

Intro and Purpose

Inspired by a real world ceramic mushroom salt and pepper shaker set, these were created as a cheap plastic alternative.


Use

Fill red mushroom (3 holes on top) with salt. Then cap with included cap. Cap may need to be resized depending on the quality of your prints. Results may vary. Repeat for green mushroom, but with pepper.


Change List

  • V1: Initial release, untested

3D printing settings

50% 1 shell for both mushrooms. Print as they would be on table (pouring holes up!)

For mushrooms optimally you need 3 colors per. For red, use white filament till underside, switch to black or grey, then when cap starts to form, switch to red. For green do exact same, but end with green instead of red. The final image shows how to do this.

10% 1 shell for caps. Print caps small diameter down, do that the knob is at the top.

  • 3D model format: STL

Tags

Creator

License

CC BY


Add a comment