This part was designed as a universal screen mount, as we had monitors without stands.
V.3.2 - Low Height Standard Stand (5 Parts X 2)
* 1 X Body
* 1 X Leg A
* 1 X Leg B
* 2 X Screw
V3.2 Updated Changes
(11/09/19) Screws and Holes added to allow locking of monitor in place
(11/09/19) Added 2 extra pins on each leg and holes in the main body to help distribute the load
(11/09/19) 2 extra sizes of the main body have been added, the 3cm and the 4cm versions
V.5 - Lifted Height Stand with Slight Tilt (7 Parts X 2)
* 1 X Base Body
* 1 X Base Screw
* 2 X Base Legs
* 1 X Tilt Body
* 2 X Tilt Screen Screws
V.5 Updated Changes
(09/09/19) Base Legs have been hollowed out to reduce the amount of material during print.
(09/09/19) Body inner dimensions increased to allow the Tilt body to fit better..
V3 = 25%. V5 = 15% (Screws 60% - 80%)
Filament: Wanhao PLA Green
(V3)When slicing, It's advised to set the pin (on the legs) to print with 100% Infill (V3)
The trick to both prints are thick walls!!