Pot in spherical form includes base for excess water.
is designed to print without media but by the spherical shape the impression is not perfect, so I have included two versions of the same piece, to improve quality may put supports and decrease the coarse finish of the print, I consider that if you are going to put supports in version 1 would be less support but version 2 any irregularity in printing either with supports or without supports will come out into the pot that at the end will be covered with soil.
I recommend printing with a thick wall of 4 layers minimum to avoid filtrations and a filling of 15% or 20% but the filling in the piece is minimum, if you use supports only to use on the plate, printed with 0.4 mm nozzle and layer height of 0.2 mm, the piece measures 100 mm in diameter and is used approximately 55g of material.
Page translated by automatic translation. See the original version.