Skip to content

Furry Hexmas Tree (single and dual extrusion)

3D model description

Merry Christmas!

Print without supports, minimal infill (I used 5%) Both versions included, single and dual extrusion.

I printed 2 trees, one at 0.2mm and the green one at 0.3, the purple one probably printed a bit better at 0.2 but both came out fine. I ran 2 shells on the green, 3 shells on the purple, 3 shells had less casualties on the branches when removing the cone.

There was a few ways I thought about doing a hairy tree, many of the attempts at branches and fancy things just yielded a painful print, where as this is about as easy a print as you can get and you can print it super fast also. Stands at just under 15cm tall, higher with the star. The Star is a bit big, but ah well.

Removal of outer cone is super easy, I just used a kitchen knife and cut around the inside, place in a bowl of hot hot water for a minute and then mold to shape, hair dryer works too but a little aggressive sometimes.

  • 3D model format: STL

Tags

Creator

Thanks for downloading, If you enjoy my models here, I guarantee you'll love the ones on my Patreon! :)
https://www.patreon.com/Geoffro

Company Info:
Hex3D Pty, Ltd
ACN 614 817 499
Contact: Geoff@hex3d.com

License

CC BY ND


Add a comment