Skip to content

zelda guardian

3D model description

zelda breath of the wild articulated guardian

  • 3D model format: STL



Page translated by automatic translation. See the original version.

Related contents

Add a comment

One comment

I tried 6 times unsuccessfully to get this model to print in my MonoPrice Maker Select V2, and could not get it to print. Unfortunately because the model is not flush down against the build surface it requires supports under the entire model, and each arm is not identical as some of the claws on each arm print as an island and a couple do not. I also loaded the model into FlashPrint to print on my Voxel, and got an error that the model had to be repaired.

If there was a way to make the model lay flat on the build surface and to make the claws have a flat bottom rather than go on an angle, I think it could print well. But unless your printer is calibrated beyond perfect, this is a very tough print as-is.