Skip to content
Free Ye Olde Arrow Through The Head Gag STL model, Zheng3

Ye Olde Arrow Through The Head Gag

3D model description

Uses a #2 Pencil for the arrow shaft. One size fits all.

This was part of a last-minute Halloween costume, but it needed some tweaks before it was Cults-worthy.

I'll be here all week! Try the veal.

3D printing settings

Cut a #2 pencil in half (a hacksaw works great for this) and attach the fletching and arrow head pieces to the two halves of the pencil.

The bore on the fletching is just a wee bit larger than the arrowhead bore so that you can fit the eraser end of the pencil into it. If the bores are too big, just wrap a piece of tape around the end of the pencil.

Jam the free edges of the pencil halves into the holes on the band. It should be a very snug fit.

  • 3D model format: ZIP

Creator

Seej patient zero. Barbie Armor Designer, artist, worst programmer ever. Mostly illiterate, but has minimal competence in spoken Mandarin. Not real clear on Ohm's law.

License

CC BY SA


Add a comment