This is a receiver holder and protector for the Turnigy 9X Receiver,
Its holds the receiver very good and fits perfectly by pression, no need screws, use a belt for mount it.
Leave positive comments, like and share it, that would help a lot!
Material: I made this impression in orange PLA.
Time: The impression takes between half an hour to 7 hours depending on the infill 10% ~ 20%
Infill: 10% ~ 20%
Build Plate Adhesion: You can use Brim if you wish but it's not necessary.
Dimensions: 46.3 x 44.2 x 38.4 mm
Hey, I'm Alex, I contribute a few part of my time to 3D printing, design stuff-parts, creation of solids and assembly models
Among several activities I like robotics and I work with technology, at the same time I've always an student for this.
Hope you like my stuff!
-I'm not rocket science
Follow me on:
Page translated by automatic translation. Suggest a better translation