Small Alphabet Train, learn and play!
All letters can be vertically print, no supports needed, they're also included on the models (except locomotive roof which can be difficult even if I succeeded to print it without support). Be carreful when you removed the supports (see prints parameters).
The train consist of:
- All letters from A to Z
- 1 locomotive
- 1 wheel
- 1 base (for designers who wants to make modifications)
For the axis, you can use a piece of filament (diameter 1.75mm) 35mm lenght, put it inside the car and put the wheel. Then, with a hot spring (ex: lighter): lightly burn the ends and flatten then. WARNING: this operation must be made by an adult!!
An other solution is to use filament (1.75mm ) or a toothpick and use glue to fix the wheels.
About 1h30 is needed to print 1 wagon and 4 wheels.
Print with a Dagoma Discovery 200
- PLA Filament
- 0.2mm (0.15 for the locomotive)
- Density 0% can be OK, but I advise to use 17% because some letters are weak, specially when supports removed.
Simple Designer sans prétentions qui souhaite juste partager ses créations.