NEW!! NEW!! NEW!!
Added corner (2nd revision)
Added new male and female room connectors
Added joiner to make female connectors into male ones
Added T junction with upright connection points (with easy to remove print supports)
Added vertical connector (with ladder)
Added NEW corrider (replacing old) - connector now has flats edges to align joins
Plug and play Subnautica 'style' Multipurpose room and corridor sections
These sections can plug together and create a basic Subnautica style base!
Wanhao Duplicator i3 V2
The models appear to be 90 degrees out - all of them will need rotating 90 degrees before printing out.
The corridor should be printed on end (the end which has the ring on it ... the ring is a support that detaches easily after printing)
The corridor to room joiner should be printed vertically (not facing down) - this may require further supports.
How I Designed This
Designed and made in 3DS Max, inspired by Subnautica.
Note that these models do not accurately represent Subnautica models as they have been visually reconstructed from scratch. Proportion and details will not be the same and modifications have been made to enable parts to plug together.