The brewing stand from Minecraft with separate potions. Just a fun, cute little model. I tried to paint mine with some Krylon, but it didn't turn out too well.
The potion requires a raft and supports to print, I used a .2 layer height but anything else should be ok. The stand was actually a little trickier than i thought it would be. It definitely needs supports and any layer height is good. But depending on your printer you may need to do something that I've never really done before, and that's increasing the support density. As it was printing the separate towers near the potion rings, I noticed that the posts would buckle back and forth, making it almost impossible for them to print correctly. The supports weren't enough for it, and with no solid attachment they suffered a lot of backlash so make sure to watch for that. Enjoy, and please post a make if you can!
Thingiverse account: https://www.thingiverse.com/Sh0rt_Stak/about