Skip to content

car holder iphone 5 / 5S / SE

3D model description

car mount (air vents) for iPhone 5 / 5S / SE with passage for jack and ligthning port. The support is intended for phones without shells. Assembly two pieces simply glued. About 1 hour 45 minutes of printing. The iphone comes in and out without forcing and is perfectly maintained.

TIP FOR PRINTING IN PLA: gradually subject the fastener to a temperature of 80 ° C for 15 minutes.

After this passage the PLA can withstand a temperature of about 110 ° C. Very important because it will be attached to the grilles of the heating of your car.

3D printing settings

printing with layers 0.20mm and in "filled" mode, with supports starting from the board.

  • 3D model format: STL



Page translated by Google Translate. Suggest a better translation

Add a comment