This is my v2.0 smartphone stand. A little bit better looking. Less material is needed. New design ques are added such as curved back. Optional "arrow" model to customize your stand with your personal touch.
2 variations available!
Big groove for the cable
I don't use the cable option but it was a request.
Please feel free to comment, let's make this design better :)
HOW TO PRINT?
Print it on it's side.
If your printer is highly tuned and you have support bridging properties, you can print it without any supports. All other printers, please use supports. Especially in the groove section/area(when on it's side)
Use any resolution you like.
Print on it's side. With supports.
Print slow, up to 60mm/s
Print the decorative arrows separately. If doesn't fit, scale down by 1-4 percent.