This is a revolving table.
Just put anything on the table, place your tripod next to it and you can take photos from each side.
It´s a very useful gadget to convert a photographed thing into a printable 3D-Model.
What you need:
- 1 axle bearing 608
- Table diameter: 200mm
- height: 95mm
It is printed in two parts. There is one thread on the table an one on the shaft. So can can easily screw it together.
Sliced with Cura
I used adaptive layers and printed the thread with a layer heigth from 0.1mm.
Don´t use any support!