Remix of my other stand that had the logo extruding from the front.
This one was made with Hatchbox wood PLA. I really love this stuff.
I took the PS Vita Stand by LordLeXaT and cleaned up the front and added a different PS Vita logo, then cut out a 2-stage channel down the center and added a channel to run the cord. The bottom half of the hole is large enough for the USB tip to fit through, but only the top half will fit the Playstation end of the cord, so it will sit high enough up for the dock to make a connection.
I used a brim to guarantee flat corners but no other support was needed.