This is a simple cartridge holder for Playstation Vita games.
I took inspiration from a Pez dispenser for this model.
The holder part should be printed vertically. It will only need some supports in the logo etched on the side.
The trays printed with no supports but I used a brim to avoid warping. I did have to shave a bit of plastic off of the bottom to get it to fit nicely. I'd avoid the brim if possible.
The letters won't fit if a brim is used either.
The holder part took 3 hours, the trays took 1 hour each and the letters took about 3 minutes to print at Standard (.18mm layer height) setting. All at 100% infill.