This is a minimal cross style case for iPhone 6/6s.
It provides essential protection for the phone landing at any angle.
The primary purpose of designing this case is making sure the arm grabbing the phone won't break.
Therefore the case was designed as two parts, each printed vertically to optimize the strength.
screen protector was not considered as I don't use it.
recommended to print at 0.1mm layer height with raft.
made the pieces wider to lock on the phone steadier
more allowance to inaccuracy
If you have a removable heated bed, after printing and installing the case on you phone, heat the bed to 70 degree Celsius, then remove the bed and place it on a table, press and rotate the back of your phone onto the heated bed with the case on. You will end up having a very flat case.
Recommended to print on raft for much more accurate edge than brim.
Ryan Huang from Melbourne