A GoPro connector for the handlebar of a bicycle.
The diameter of the handlebar and the length of the arm is customizable.
Three M4 screws (DIN 933, 2x16mm & 1x20mm) and self-locking nuts are needed for the handlebar connector.
Two M5 screws (DIN 933, 20mm & 50mm) and nuts are needed for the GoPro connectors.
I glued half of a bicycle patch in each of the handlebar connectors - to have a better grip on the handlebar (see photo).
The screw_handle needs a screw M5x50, an additional nut and some hot glue.
The case for the GoPro Hero 5 is this one: https://cults3d.com/en/3d-model/gadget/case-for-gopro-hero5-no-support-needed
25% - 100% (depends on the part / decide for yourself)
The design was made to allow printing without support and also have areas, where stress occurs, be printed in one piece (without retraction).