Skip to content

Ash Williams Chainsaw Hand (Evil Dead II & Army Of Darkness)

3D model description

This is a prop replica of the chainsaw seen in the Evil Dead series and Army of Darkness. The model includes The chainsaw body, the blade (but no stationary chain yet), the side handle, gas caps, a pull handle, the side (exhaust?) disk, an inside handle for holding when wearing this as a costume piece (it also has a slot for a button in the center of the handle in case you want to add electronics), as well as a few pieces for the top handle and hand slot. You will have to buy nuts and screws to put the top handle together. I recommend buying a kit with a variety of screw sizes to fit your needs. The chainsaw was made with electronic components in mind, but they're not necessary. I took the "chain" off of a halloween prop with a motor and sounds and installed them in mine. I may model a stationary chain for those of you who do not want to spend money on electronics and just want the blade to be stationary. Eventually I will be uploading a model for the "Boomstick" and later a video showing me putting my full cosplay together. To make this model yourself, you may have to scale the chainsaw up or dremel the hand hole in the back of the chainsaw to make it easier to slide your hand inside. Just be sure to scale up all the pieces if you do want a bigger chainsaw. I hope you enjoy!

  • 3D model format: STL





Related contents

Add a comment