Recently i've start being active in Twitter.
Some of my tweets are small OpenSCAD figures using less than 140 characters.
I printed 3 of them and i decided to share.
I have much fun writting creative code that fits in a tweet. I encourage to all the OpenSCAD programmers to try and share their own tweets.
Copy-Paste this code in OpenSCAD, try and tweak to get your own versions.
for(i=[0:360]) rotate([0,i*0.25,i*137.5]) translate([2*sqrt(i),0,0]) rotate([0,i*0.15+30,0]) cylinder((i%7==0)?i/25:2,4,0.5);
Vase / Planter
And of course...Have fun!
BQ Prusa i3 Hephestos
0.2 it's ok
Rotate the Egg 180º and add a Brim to have a good bed adhesion.
Use 'vasemode' for the vase (see belowhow to do it in Cura)
Vase Mode in Cura
Hi all! , I'm Fernando Jerez, computer science teacher, amateur designer and electronics noob.
Love procedural/generative stuff, robots, and all kind of 3D printable stuff.
Hope you enjoy my designs.
Contact me by private message: @ferjerez3d (Instagram,Twitter)